新聞資訊

NEWS

用了這么多年的生料帶你都纏繞對了嗎

2021-11-18 15:27

   生料帶(化學名稱是聚四氟乙烯)是水暖安裝中常用的一種輔助用品,用于管件連接處,增強管道連接處的密閉性。生料帶是一種新穎理想的密封材料。由于其無毒、無味、優良的密封性、絕緣性、耐腐性,被廣泛應用于水處理、天然氣、化工、塑料、電子工程等優先域。

 
  Raw material tape (chemical name is polytetrafluoroethylene) is a commonly used auxiliary equipment in water heating installation, used for pipe fittings connection, to enhance the sealing of pipe joints. Raw meal belt is a novel and ideal sealing material. Because of its non-toxic, tasteless, excellent sealing, insulation, corrosion resistance, it is widely used in water treatment, natural gas, chemical, plastic, Electronic Engineering and other fields.
 
  日常生活中,我們有時候自己動手安裝角閥、水龍頭、水管等,纏繞生料帶的時候總是纏不好,水龍頭總是漏水、滲水,這是怎么回事?該如何纏繞生料帶呢?
 
  In our daily life, we sometimes install angle valves, taps, pipes, etc. by ourselves. When we wrap the raw material tape, it always doesn't wrap well. The tap always leaks and seeps. What's the matter? How can we wrap the raw material tape?
 
  1、先將生料帶要連接部位的異物清除干凈,然后沿著管道絲口外緣向內進行纏繞。
 
  1. Clean up the foreign body in the connecting part of the raw material belt first, and then wind it inward along the outer edge of the pipe opening.
 
  2、注意纏繞方向,以角閥為例,角閥在擰進墻里內絲螺紋的時候,是向右順時針旋轉的,那我們在角閥上纏生料帶的方向就是向左逆時針纏繞,這樣擰角閥的時候會越擰越緊,不會松脫。纏繞過程中注意生料帶平整,保證絲口被生料帶完全包裹。
 
  2. Pay attention to the direction of winding. Take the angle valve as an example. When the angle valve is screwed into the wall, it rotates clockwise to the right. Then we wrap the raw material belt on the angle valve in the direction of counterclockwise to the left. In this way, the tighter the angle valve is, and it will not loose. Attention should be paid to the raw material strip formation during the winding process to ensure that the silk thread is completely wrapped by the raw material belt.
 
  3、纏的時候要拉緊生料帶,讓生料帶緊密貼附在螺紋上,盡量緊,不要纏松了,纏完要用手轉圈壓緊,也可以一邊壓緊一邊纏。纏繞2-3圈,完成后絲口邊緣比絲口內側生料帶稍厚。
 
  3. When wrapping, tighten the raw material belt, so that the raw material belt tightly attached to the thread, as tight as possible, do not loosen the wrapping, wrapped with a hand to tighten the circle, you can also tighten while wrapping. Wrap around 2-3 circles. After finishing, the edge of the wire edge is slightly thicker than that of the inner side of the silk mouth.
 
  4、至于纏繞“幾層”沒有硬性規定,以能旋緊、不滲漏為準,但根據經驗,通常需要纏繞十幾圈以上才能保證密封效果。纏繞完成后,用手指環捏一下,使之和絲口貼合。
 
  4. As for winding "several layers" without rigid provisions, to be able to tighten, no leakage as the standard, but according to experience, usually need to winding more than a dozen circles to ensure sealing effect. When the winding is finished, use the finger ring to pinch it, so that it fits perfectly with the silk thread.
 
  5、擰螺紋的時候不要往死里擰,并不一定非要擰到實在擰不動才不漏,只要擰的時候手感能吃上勁就可以。另外要注意擰進去的深度,比如冷熱水混水閥的兩個彎腳對絲,擰的時候就要注意保持出墻距離一致,尤其是在墻里兩個內絲彎頭深度不一致的情況下。握住纏好的連接件順時針方向擰到位。
 
  5. When screwing a thread, do not screw it to death. It does not necessarily have to be screwed to the point where it can't be screwed. In addition, attention should be paid to the depth of the screw in, such as hot and cold water mixing valve two bending feet against the wire, when screwing, attention should be paid to maintaining the same distance from the wall, especially in the wall of the two internal wire bend depth is not consistent. Hold the wrapped connector and turn it in clockwise direction.
 
  想要避免管道接口出現漏水、滲水的現象,除了要掌握正確的生料帶纏繞方法,還得使用質量可靠的生料帶,貝貝鯨生料帶就值得放心選購、安心使用。
 
  In order to avoid leakage and seepage at the pipe interface, besides mastering the correct winding method of raw material belt, and using the reliable raw material belt, the raw material belt of Beibei whale is worth purchasing and using safely.
 

国产欧美日韩一区二区搜索_被夫の上司持久侵犯耻辱在线_亚洲另类无码专区丝袜_亚洲精品nv久久久久久久久久